HP-450 60 Amp DC Power Supply
Matching 60A DC Power Supply for HL-450B as well as HL-350VDX.
- Light weight design due to switching mode operating system.
- Best suited for feeding DC 13.8V / 60A of power to radio equipment to be operated at home and base station.
- Over-current protection circuit will work to decline both output voltage and current to avoid damage of the power supply, when load current exceeds the maximum limit.
- Designed to be free from RF intrusion that makes operation instable.
- Voltage drop across the output DC cables can be cancelld, when REMOTE Sensing terminal is used.
The HP-450 is capable of delivering 60Amps continuously, with a duty cycle of 8 hours. The power supply incorporates an extremely precise voltage regulation circuit, maintaining the output voltage within 2%.
Output voltage can be selected via the front voltage knob. There is a front mounted meter switch, so the user can select what is displayed on the meter, either amperage or volts
There is a voltage feedback terminal strip mounted on the rear of the unit. A pair of sense wires can be connected to the input power terminals of the device and the power supply. This sense circuit will measure the voltage drop on the device and adjust the power output to keep the voltage locked at the desired voltage. No longer do you need to be concerned about voltage drop on the device under heavy amperage draws. The HP-45 will automatically compensate for such situations.
The unit incorporates robust RF shielding which can make ordinary power supplies unstable. An additional feature of over amperage protection, it will reduce both the voltage and amperage, thereby protecting the powered device.
A single HP-450 can also be used for unusually high amperage devices, where two power supplies would normally be used, such as the Kenwood TS-480HX 200 watt radio.
Front Panel contains power switch, AC line voltage warning LED, Overload (amperage) warning LED, Meter with amperage and voltage scales, meter select switch for amperage or voltage, variable voltage output selection knob. Behind the pull down door: A 6 amp terminal strip and a 10 amp Cigarette DC power outlet.
Rear panel contains D.C. Output terminals, sense line terminals and A.C. power cord receptacle.
||AC 100 ~240V
50 / 60Hz
||DC 13.8V, 60A max
8 hours continuous
DC voltage adjustable
1 ~ 15V
||Within 2% at rated maximum condition of 13.8V / 60A
||5mV max RMS
@ 13.8V / 60A load
||Forced Air Cooling
||Carrier operated auto send-receive switch.
LED power level indicator. Terminal for external remote controller.
GaAs FET RX pre-amp.
||Approx. 8.3 x 4.3 x 15
inches (W x H x D)
||Approx. 13 lbs.